Cabinetry, Cutout for 30, 2 cm) – GE PT925DNBB User Manual
Page 7
7
NOTE: The middle rail separating the two
openings may need to be larger than the 2”
(5.1 cm) minimum shown. Always refer to the
individual installation instructions packed with
each product for specifi c requirements.
Combined Advantium or Microwave
Oven and Wall Oven Installation:
When
installed in combination with a single wall oven,
use separate electrical junction boxes.
• Refer to the Advantium or microwave
oven installation instructions for electrical
requirements of that product.
• These connections must be made by a
qualifi ed electrician. All electrical connections
must meet National Electrical Code or
prevailing local codes.
NOTE: Additional clearances may be required.
Check to be sure the oven supports above the
Warming Drawer do not obstruct the required
interior depth and height. The middle rail
separating the openings may need to be larger
than the 2” (5.1 cm) minimum shown. Always
refer to the individual installation instructions
packed with each product for specifi c
requirements.
Warming Drawer Combined with
Advantium or Microwave Oven and
Single Oven:
Install a separate 120V, 60Hz, properly
grounded receptacle. See installation
instructions packed with each product
for specifi c requirements.
Note: Install the
oven only with spe-
cifi c models listed
on the label located
on top of the oven.
Cabinetry
Single Double 30” (76.2 cm)
Oven Below an Advantium
or Microwave Oven
Single Double 30” (76.2 cm)
Oven Between an Advantium
or Microwave Oven and a
Warming Drawer
2” (5.1 cm) Min.
Per Advantium or
Microwave Oven
Requirement
Cutout for 30”
(76.2 cm)
Single Double Wall Oven
Below an Advantium or Microwave Oven or
Between an Advantium or Microwave Oven
and a Warming Drawer
A
2” (5.1 cm) Min.
2” (5.1 cm) Min.
Per Advantium or
Microwave Oven
Requirement
Per Warming
Drawer
Requirement