GE PT925DNBB - Manual (Page 12)

12
Installation Instructions
Remove all protective fi lm, if present,
and any stickers.
Check to be sure that all wiring is secure
and not pinched or in contact with
moving parts.
Pre-Test Checklist
Check that the bottom trim is installed
properly (see page 11).
Check to be sure the mounting screws
are installed and fl ush with the side trim
(see page 10).
Remove all items from the inside
of the oven.
Check that conduit is securely
connected to the junction box.
Turn on the power to the oven. (Refer to
your Owner’s Manual.) Verify that the
bake and broil units, and all cooking
functions operate properly.
Check that the circuit breaker is not
tripped nor the house fuse blown.
See your Owner’s Manual for
troubleshooting list.
Operation Checklist
NOTE TO ELECTRICIAN: The power
leads supplied with this appliance
are UL recognized for connections
to larger gauge household wiring.
The insulation of these leads is rated
at temperatures much higher than
the temperature rating of household
wiring. The current carrying capacity
of a conductor is governed by the wire
gauge and also the temperature rating
of the insulation around the wire.
NOTE: ALUMINUM WIRING
A.
WARNING
: IMPROPER
CONNECTION OF ALUMINUM HOUSE
WIRING TO THE COPPER LEADS CAN
RESULT IN AN ELECTRICAL HAZARD
OR FIRE.
B. Splice copper wires to aluminum
wiring using special connectors
designed and UL approved for
joining copper to aluminum,
and follow the manufacturer’s
recommended connector
procedure closely.
NOTE: Wire used, location and
enclosure of splices, etc., must
conform to good wiring practice
and local codes.