GE PT925DNBB - Manual (Page 10)

10
Installation Instructions
Securing the Oven in the Opening
Sliding the Oven Into the
Opening
a. Loop (do not tie) a 72” (183 cm) string around
the conduit before the oven is slid into place.
This will keep the conduit from falling behind
the oven.
b. Lift oven into cabinet cutout using the oven
opening as a grip. Do not lift the door by the
handle! Carefully push against oven front
frame. Do not push against outside edges.
c. As you slide the oven back, pull the string
so that the conduit will lie in a natural loop,
behind the oven.
d. When you are sure the conduit is out of the
way, slide the oven 3/4 way back into the
opening. Remove the string by pulling on one
end of the loop.
C
C1
Pull out on string
loop while push-
ing the oven into
the cabinet
Installing the Metal
Bottom Trim
IMPORTANT: If this unit is ever removed
from the cabinet or the oven is ever
pulled out for service, pull unit out 4” and
remove the bottom trim. This will prevent
damage to the trim.
C2
Bottom Trim
Trim Screw
Install bottom trim
with unit 4”
out of cabinet
a. Place the bottom metal trim under air
divider, with side fl ush against side trim.
Do this with the unit 4” out of the cabinet.
b. Using two trim screws provided, secure
the bottom trim to the bottom duct asm.
4”