HP LaserJet 4000 Printer series User Manual

Page 100

Chapter 4: Problem Solving

Does the printer select the proper trays,

output locations, and paper handling
accessories?

YES

For other

problems,

check the

Contents, the

Index, or

the printer

software help.

The printer

pulls from the

wrong tray.

An optional

accessory is not

working

properly.

A message other

than

4'#&;

displayed.

Make sure paper trays are correctly
configured for paper size and type
(page 52). Print a configuration
page to see current tray settings
(page 94).

Make sure the tray selection (or
paper type) in the printer driver or
software application is set correctly.
(The printer driver and software
application settings override the
printer’s control panel settings.)

If you do not want to print from
Tray 1, remove any paper loaded in
the tray or change the

64#;/1&'

setting to

%#55'66'

(page 50). By

default, paper loaded in Tray 1 will be
printed first.

If you want to print from Tray 1, but
cannot select the tray from a
software application, see page 50.

Print a configuration page to verify
that the accessory is installed
properly and is functional (page 94).

Configure the printer driver for the
installed accessories (see the
software help).

Turn the printer off, and then turn the
printer on.

Verify that you are using the correct
optional accessory for the printer.

If the optional duplexer will not
duplex, check that the rear output bin
is closed.

If the optional duplexer will not
duplex, you might need to install more
memory (page C-1).

Go to page 72.