Alpine MDA-W890 - Manual (Page 36)

36
English
Radio Operation
1
Manual Storing of Station
Presets
1. Tune in the desired radio station you wish to
store in the preset memory.
2. Press and hold any one of the preset
buttons (
1
through
M 6
) for at least 2
seconds. The frequency display will begin
to blink.
3. Press the preset button into which you wish
to store the station while the display is
blinking (within 5 seconds).
The display stops blinking once the station
has been memorized. The display shows the
band, preset No. and the station frequency
memorized.
4. Repeat the procedure to store 5 other
stations onto the same band.
To use this procedure for other bands,
simply select the band desired and follow
steps 1 – 3 above.
A total of 24 stations can be stored in the preset
memory (6 stations for each band; FM1, FM2,
AM and D.A.P.).
Notes:
•
“Preset memory” works when the function
mode is OFF.
Refer to "Using the Function button" on page
30.
• If you store a station in a preset memory
which already has a station, the current
station will be cleared and replaced with the
new station.
1
3
2
1
M
H
CT
6
5
4