HP ProLiant BL25p G2 Server-Blade - Manual (Page 30)

Hardware options installation 30
• Supported SAN and associated software
For more detailed SAN configuration information for the server blade, refer to:
• The model-specific QuickSpecs document located on the HP ProLiant p-Class server blade products
web page at the HP website ( http://www.hp.com/products/servers/proliant-bl/p-class/info )
• The HP StorageWorks SAN documentation at the HP website
( http://h18006.www1.hp.com/products/storageworks/san/documentation.html )
• The HP BladeSystem p-Class storage website ( http://www.hp.com/go/bladesystem/storage )
To install the component:
1. Power down the server blade (on page 13 ).
2. Remove the server blade (on page 14 ).
3. Remove the access panel (on page 14 ).
4. Align the FC mezzanine with the FC connectors.
5. Install the FC mezzanine. Press down above the connectors to seat the board.
6. Install the access panel.
7. Install the server blade (" Installing a server blade " on page 20 ).
8. If connecting to a SAN, install one of the interconnect device options. See the interconnect device
option documentation.
NIC mezzanine option
1. Power down the server blade (on page 13 ).
2. Remove the server blade (on page 14 ).
3. Remove the access panel (on page 14 ).
4. Align the NIC mezzanine with the NIC mezzanine connector.