HP ProLiant BL280c G6 Server-Blade - Manual (Page 43)

Hardware options installation 43
19. (Optional) Install the BBWC battery pack on the air baffle. If excess BBWC cable exists, loop and store
the extra cable in the available space on the air baffle.
20. Install the access panel (on page 13 ).
21. Install the server blade (" Installing a server blade " on page 18 ).
HP Trusted Platform Module option
Use these instructions to install and enable a TPM on a supported server blade. This procedure includes three
sections:
1. Installing the Trusted Platform Module board (on page 44 ).
2. Retaining the recovery key/password (on page 45 ).
3. Enabling the Trusted Platform Module (on page 45 ).
Enabling the TPM requires accessing the ROM-Based Setup Utility (RBSU) (" HP ROM-Based Setup
Utility " on page 58 ). For more information about RBSU, see the HP website
( http://www.hp.com/support/smartstart/documentation ).
TPM installation requires the use of drive encryption technology, such as the Microsoft® Windows®
BitLocker™ Drive Encryption feature. For more information on BitLocker™, see the Microsoft website
( http://www.microsoft.com ).
CAUTION: Always observe the guidelines in this document. Failure to follow these guidelines
can cause hardware damage or halt data access.
When installing or replacing a TPM, observe the following guidelines:
• Do not remove an installed TPM. Once installed, the TPM becomes a permanent part of the system
board.
• When installing or replacing hardware, HP service providers cannot enable the TPM or the encryption
technology. For security reasons, only the customer can enable these features.
• When returning a system board for service replacement, do not remove the TPM from the system board.
When requested, HP Service provides a TPM with the spare system board.