HP ProLiant BL280c G6 Server-Blade - Manual (Page 27)

Hardware options installation 27
12. Remove the thermal interface protective cover from the heatsink.
13. Align and install the heatsink. Alternate tightening the screws until the heatsink is seated properly.
14. Install the air baffle (on page 13 ).
15. If removed, connect the hard drive power and data cables to the system board (" Hard drive connector
identification " on page 9 ).
16. Install the access panel (on page 13 ).
Memory options
IMPORTANT: This server blade does not support mixing RDIMMs and UDIMMs. Attempting to
mix these two types causes the server to halt during BIOS initialization.