Load a roll into the printer (automatically) – HP Designjet L25500 Printer series User Manual
Page 23
9.
Put the blue stop on to the upper end of the spindle, and push it towards the end of the roll.
TIP:
If the cardboard core of the substrate is longer than the substrate, you can load the media
without inserting the blue stop, but care should be taken when unloading the media, as the loading/
unloading table is designed to be used with the blue stop in place.
10.
Slide the lever-lock to the locked position.
11.
Lift the loading table to ease the spindle into the printer.
CAUTION:
To avoid trapping your fingers, do not push the roll with your hands.
If you regularly use different substrates, you can change rolls more quickly if you pre-load rolls of different
substrates on different spindles. Extra spindles are available for purchase.
Load a roll into the printer (automatically)
To start this procedure, you need to have a roll loaded on the spindle. See
The normal minimum substrate width is 23 inches (584 mm). To load substrates down to a minimum
width of 10 inches (254 mm), go to the front panel and select the icon, then select Substrate handling
ENWW
Load a roll into the printer (automatically)
19
Hand
le the su
bstrate