HP ProLiant ML310 G4 Server - Manual (Page 29)

Hardware options installation 29
7. Install the access panel (on page 17 ).
8. Install the bezel (" Unlock the tower bezel " on page 17 ).
9. Power up the server (on page 16 ).
DVD-ROM drive
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays
are populated with either a component or a blank.
1. Power down the server (on page 16 ).
2. Remove the bezel (" Unlock the tower bezel " on page 17 ).
3. Remove the access panel (on page 17 ).
4. Disconnect the cables from the rear of the CD-ROM drive.
5. Remove the CD-ROM drive.
6. Slide the DVD-ROM drive into the media drive bay.
7. Connect the DVD-ROM drive cable to the rear of the DVD-ROM drive and to the DVD-ROM drive
cable connector on the system board (" System board components " on page 10 ).