HP ProLiant DL580 G7 Server - Manual (Page 29)

Operations 29
2. After the display fully ejects, rotate the display downward to view the LEDs.
Remove the SPI board
To remove the component:
1. Power off the server.
2. Extend the server from the rack (on page 25 ).
3. Remove the access panel (on page 26 ).
4. Disconnect all cables from the SPI board.
IMPORTANT: If replacing the SPI board or clearing NVRAM, you must re-enter the server serial
number through RBSU (" Re-entering the server serial number and product ID " on page 79 ).