HP XP P9500 Storage - Manual (Page 65)

][-location ][-mp_blade_id ]
[-clpr ]
Check with the attribute setting
It is checked whether the operation is performed for the existing LDEV or not. If the operation is
attempted to be performed for an LDEV that does not exist, an error is detected.
If it is not clear whether the LDEV as the target of the operation exists in the configuration definition
file (if the target LDEV information does not exist in the configuration definition file), the error is not
detected.
The command as the target of the check is shown below.
•
raidcom add lun -port [] {-ldev_id [-lun_id] |
-grp_opt -device_grp_name []}
•
raidcom delete lun -port [] {-lun_id | -ldev_id |
-grp_opt -device_grp_name []}
•
raidcom add journal -journal_id {-ldev_id …[-cnt] | -grp_opt
-device_grp_name []} [-mp_blade_id
| -timer_type ]
•
raidcom delete journal -journal_id [-ldev_id | -grp_opt
-device_grp_name []]
•
raidcom add snap_pool {{-pool_id [-pool_name ] | -pool_name
[-pool_id ]} | -pool_id -pool_name }}
{-ldev_id …[-cnt] | -grp_opt -device_grp_name group name> []}[-user_threshold <%>]
•
raidcom add thp_pool {{-pool_id [-pool_name ] | -pool_name
[-pool_id ]} | -pool_id -pool_name }
{-ldev_id …[-cnt ] | -grp_opt -device_grp_name group name> []}[ -user_threshold []]
•
raidcom extend ldev {-ldev_id | -grp_opt -device_grp_name group name> []} -capacity | -offset_capacity | -cylinder
•
raidcom check_ext_storage external_grp {-external_grp_id | -ldev_id |
-grp_opt -device_grp_name []}
•
raidcom add device_grp -device_grp_name -ldev_id
… [-cnt ]
•
raidcom delete device_grp -device_grp_name -ldev_id… [-cnt
]
•
raidcom modify ldev -ldev_id {-status [] | -ldev_name
| -mp_blade_id | -ssid | -command_device < y/n > [Security value]}
•
raidcom initialize ldev {-ldev_id | -grp_opt -device_grp_name group name> []} -operation
Check with the deletion operation
It is checked to ensure that the operation is not intended to be performed for the LDEV that is already
deleted. If it is, an error is detected.
If it is not clear whether the LDEV as the target of the operation exists in the configuration definition
file or not (if the target LDEV information does not exist in the configuration definition file), the error
is not detected.
Command execution modes 65