Suggested action, Cause, Cause suggested action – HP Insight Control User Manual
Page 55
Suggested action
Reset the iLO network settings on the destination server, and then retry the automatic booting or
manually boot the destination server. For more information on iLO, see the iLO user guide.
Insight Control server migration stops responding during automatic booting of
Microsoft Hyper-V virtual machine
Insight Control server migration might stop responding during automatic booting of a Microsoft
Hyper-V virtual machine for an X2V migration.
Suggested action
Ensure the following:
•
File sharing is enabled on the application station and the Microsoft Hyper-V host.
•
The Server or Workstation service is started on the application station and the Microsoft
Hyper-V host.
•
A "Client for Microsoft Networks" client is added to the network interface properties on the
application station and on the Microsoft Hyper-V host.
Application station fails to connect to the destination server when the server is
automatically booted for an X2P migration
The application station can fail to connect to the destination server when the server is automatically
booted for a P2P or V2P migration, even though the destination server boots and the agent starts.
Cause
This issue might happen if the destination server has multiple NICs connected to different networks
and the IP address is configured to a NIC that is not on the same network as the application station
and the source server. Make sure that the duplex settings on the destination server match the duplex
settings on the network switch in your environment. You can also use the autonegotiate option at
either end to ensure proper communication between the destination server and the network switch.
The application station might also fail to connect if you have a gateway in your network and the
gateway value is not specified in the migration wizard when you are identifying the destination
server.
Suggested action
Manually boot the destination server, and then manually assign the IP address to the NIC that is
on the same network as the application station.
To resolve the gateway issue, make sure that you enter the gateway IP address in the migration
wizard when you are identifying the destination server.
Warning message is not displayed for an unsupported server when the server is
started using the Insight Control server migration ProLiant Boot CD
HP Insight Control server migration does not support HP ProLiant Server versions G1 to G4. When
the unsupported server is started using the Insight Control server migration ProLiant Boot CD, the
migration wizard does not display the message that the server is not supported.
Suggested action
Before you start the migration, verify that the server is supported. For a list of supported servers,
see HP Insight Management Support Matrix at
.
Destination preparation
55