HP LaserJet 5000 Printer series - Manual (Page 95)

EN
Chapter 4: Problem Solving 83
RAM DISK FILE
SYSTEM IS FULL
Delete files and then try again, or turn the printer off, and then turn
the printer on to delete all files on the device. (Delete files using
HP JetAdmin, HP FontSmart, or another software utility. See the
software help for more information.)
If the message persists, increase the size of the RAM disk. Change
the RAM disk size from the Configuration Menu in the printer’s control
panel (page B-13).
RAM DISK IS
WRITE PROTECTED
The RAM disk is protected, and no new files can be written to it.
Disable the write protection through HP JetAdmin.
TRAY x EMPTY
Load the empty tray (
x
) to clear the message.
If you do not load the specified tray, the printer will continue printing
from the next available tray, and the message will continue to display.
TRAY x LOAD
[TYPE] [SIZE]
Load the requested paper into the specified tray (
x
). (See the sections
on loading paper, starting on page 30.)
Ensure that the trays are correctly adjusted for size. The size
displayed on the front of the paper tray must match the size of paper
loaded in the tray. The tray type settings (and size for Tray 1) must be
set from the printer’s control panel (page 60).
If you are trying to print A4 or letter size paper, and this message
appears, make sure the default paper size is set correctly from the
Printing Menu in the printer’s control panel.
Press [Go] to print from the next available tray.
Press [-Value+] to scroll through the available types and sizes. Press
[Select] to accept the alternate type or size.
UNSUPPORTED SIZE
IN TRAY [YY]
An external paper handling device detected an unsupported paper
size. The printer will go offline until the condition is corrected.
USE [TYPE]
[SIZE] INSTEAD?
If the requested paper size or type is not available, the printer asks if
it should use another paper size or type instead.
Press [-Value+] to scroll through the available types and sizes. Press
[Select] to accept the alternate type or size.
WAIT FOR PRINTER
TO REINITIALIZE
The RAM disk setting has been changed from the printer’s control
panel. This change will not take effect until the printer reinitializes.
Printer Messages (Continued)
Message Explanation or Recommended Action