HP Integrity NonStop J-Series - Manual (Page 14)

Method 2: If WASAP was installed using the Wizard, then to uninstall it the
configuration files need to be changed manually as described below:
Note: Please make sure Web ViewPoint is not running during installation/uninstall
of Web ViewPoint ASAP.
The following files needs to be changed to uninstall Web ViewPoint ASAP
1. WVPCONF - Remove Section
[PLUGINOBJECT]
OBJECTFILE $.WASAP1.WASAP
OBJECTID OBJID_ZWASAP
.........
.........
ASSIGN
LICENSE-FILE, LICFILE
2. WVPMENU - Remove Section
[FUNCTION]
CAPTION WASAP
FNID fnid_ZWASAP
..........
..........
REMOTESYSTEMURLSEARCHPREF
Variable
3. STRTWVP - Remove Lines
PARAM WASAPENV-BHA $A.B (Depends on the Environment setup
during Install)
PARAM ASAPCI $E.F (If present)
RUN $.WASAP1.TERMMAN /NAME $TM, NOWAIT, TERM
$ZHOME, PRI 140/
CLEAR PARAM WASAPENV-(env name) (depends on how many env
you have)
4. STOPWVP - Remove Line
STOP $TM (Depends on what you entered during Installation and if
present)
RUN ..SHUTWAS .
STATUS *, PROG ..*, STOP
Web ViewPoint ASAP User Guide – 528941-003
14