HP XP Array Manager Software - Manual (Page 47)

The Change upper-limit window is displayed ( Figure 16 ).
b. To assign an upper-limit to the I/O rate, enter the upper-limit value and then select IOPS from
the list. Next, click OK.
To assign an upper-limit to the transfer rate, enter the upper-limit value and then select MB/s
from the list. Next, click OK.
5. In the Performance Control window, click Apply.
The settings in the window are applied to the storage system.
Figure 16 The Change Upper-Limit Window
.
NOTE:
To confirm an upper-limit value specified for each Performance Control group, select the Subsystem
folder in the lower-left tree of the WWN tab. The Performance Control groups are displayed in the
list and you can confirm each upper-limit value.
Renaming a Performance Control Group
To rename a Performance Control group, take the following steps:
1. Start XP Performance Control (see “ Starting XP Performance Control ” on page 32).
The Performance Control window is displayed.
2. Click the WWN tab ( Figure 4 on page 20).
3.
In the lower-left tree, select and right-click a Performance Control group ( ).
4. Select Rename Performance Control Group from the pop-up menu.
The Rename Performance Control Group window is displayed (
Figure 17 ).
5. Enter the new name and select OK.
6. In the Performance Control window, click Apply.
The settings in the window are applied to the storage system.
XP24000/XP20000 Performance Control User Guide 47