HP Server tc3100 series - Manual (Page 23)

Chapter 3 Hardware Installation and Configuration
Server is powered down. Serious injury may result if this
warning is not observed.
2.
You must plug the Remote Management Card into slot 6.
Connecting the 50-pin Ribbon Cable to the Server
After you have physically installed the HP Server Remote Management Card into
slot 6 of your server, you must cable the card to the server's system board. One
end of the supplied ribbon cable should already be connected to the Remote
Control Card (see previous section). Connect the other end to the system board’s
50-pin connector that is immediately adjacent to the inserted card.
NOTE The ribbon cable is keyed to prevent incorrect cable
connection.
Figure 3-2: Installing the Remote Management Card
17