Installing the diagnostic panel, Connecting the cable – HP Server tc3100 series User Manual
Page 116
Appendix I
Installing the Visual Diagnostic Panel
Installing the Diagnostic Panel in the tc4100 HP
Server
Installing the Diagnostic Panel
1. Power down the HP Server.
2. Disconnect the power cord(s).
WARNING
The power supplies continue to provide standby voltage to the
HP Server until the power cord(s) is/are disconnected.
3. Remove the cover.
4. Snap the Diagnostic Panel into place, as shown in Figure I-3.
NOTE
Wear a wrist strap and use a static-dissipating work surface
connected to the chassis when handling components. Ensure
that the metal of the wrist strap contacts your skin.
Connecting the Cable
The tc4100 HP Server is shipped from the factory with a short cable that is
connected on one end to the front panel. The other end is free, waiting to be
connected to the Visual Diagnostic Panel after it is snapped into place, as shown
in the figure.
110