HP XP P9000 Command View Advanced Edition Software - Manual (Page 204)

Value displayed in Direction
option
Present copy direction Copy direction
Forward Forward Forward + Reverse + No direction
TIP:
The Direction or Synchronization option should be specified, but not at the same time. The Direction
option is available only when the copy type is Continuous Access Synchronous. For and Continuous
Access Journal, both options are available.
Details of copy pair operation options (mainframe systems)
Copy type: Cnt Ac-S
Remarks
Default
value Specifiable val-
ues
Item specified Options
Pair com-
mand
Forward: The SUSPOP status is set so
that the copy direction after
re-synchronization is from the primary
site to the secondary site.
Reverse: The SUSPOP status is set so that
the copy direction after
re-synchronization is from the secondary
site to the primary site.
Note: This option cannot be specified if
the operation target is a copy pair or a
C/T Group. This option can be specified
when the operation target is a copy
group.
Forward Forward, Reverse
The copy direction
of the pair when
re-synchronization
is performed.
Direction
split
SELECT(ALL),VOLUNIT is specified in the
BCM command. The command is also
executed for pairs whose status is not
available for the command. The
command is executed on a pair basis
even though execution by group is
possible.
Note: The Force option affects all pairs,
regardless of their individual statuses.
off on, off
The operation is
performed on a
volume basis. The
command is ex-
ecuted for all
pairs regardless of
their status.
force
The values "Read Only" and "Read
Write" are displayed in this order.
Read Only
Read Only, Read
Write
Whether to permit
writing to the S-
VOL after the split
operation.
Secondary
Mode
Managing pair life cycle 204