D tn6530 control codes and escape sequences – HP Integrity NonStop H-Series User Manual
Page 187
D TN6530 Control Codes and Escape Sequences
This appendix summarizes the 653X terminal control codes and escape sequences that are supported
by TN6530.
“ TN6530 Control Codes and Escape Sequences” (page 187)
lists the control and
escape sequences that TN6530 does not support;
lists the control and escape sequences
that are supported.
Table 24 Unsupported Control and Escape Sequences
Function
Control/Escape Sequence
Cancel line
CAN (18H)
Set single-width characters
ESC - X
Set 80-column format
ESC - Y
Set 132-column format
ESC - Z
Print page
ESC - 0
Disconnect modem
ESC f
Set double-width characters
ESC t
Set I/O device configuration
ESC x
Read I/O device configuration
ESC y
Table 25 Supported Control and Escape Sequences
Function
Control/EscapeSequence
Sound bell (audible alarm)
BEL (07H)
Backspace (cursor left)
BS (08H)
Horizontal tab
HT (09H)
Line feed (cursor down)
LF (0AH)
Carriage return
CR (0DH)
Set buffer address*
DC1 (11H)
Set cursor address
DC3 (13H)
Escape sequence header
ESC (1BH)
Start field*
GS (1DH)
Set buffer address extended*
ESC - C
Clear memory to spaces extended*
ESC - I
Set cursor address extended*
ESC - D
Read with address extended*
ESC - J
Read with address all extended*
ESC - K
Set tab
ESC 1
Clear tab
ESC 2
Clear all tabs
ESC 3
Set video attributes
ESC 6
* Sequences used in block mode only
** Sequences used in conversational mode only
187