Roll out of paper procedure, Load a single sheet – HP Designjet T1100 MFP series User Manual
Page 62
2.
Select Unload paper.
3.
Continue from step two of the
Unload paper
key process.
Roll out of paper procedure
If the end of the paper is no longer attached to the roll use the following procedure.
1.
If you have already started the unload process, press the
Cancel
key on the front panel to cancel
that procedure.
2.
Lift the blue lever on the left. If the front panel displays a warning about the lever, ignore it.
3.
Pull out the paper from the printer. Pull from wherever the paper is accessible; the back of the
printer is recommended.
4.
Lower the blue lever.
5.
If the front panel displays a warning message, press the
OK
key to clear it.
Load a single sheet
There are two ways to load a sheet. The easy loading procedure is recommended.
CAUTION:
Any loaded roll or sheet must be unloaded before loading a sheet, see
, and
Unload a single sheet on page 53
.
CAUTION:
For sheets thicker than 0.5mm, you must have space behind the printer equal to
the length of the sheet.
50
Chapter 5 Paper handling
ENWW
P
ape
r ha
ndl
ing