HP OneView for Microsoft System Center - Manual (Page 15)

Table 2 Pre-supplied files (continued)
Description File
Enables Remote Desktop pass-through hponcfg-rdpassthrough.xml
Enables agentless management on iLO4-based servers. This file may require
editing before being used. hponcfg-agentless.xml
To use a custom configuration file:
1.
Browse to .\OSD\Lib\Packages\HP\ProLiant\HWConfig.
2. Create a new file by copying and editing an existing file, starting with a blank file, or using
an existing file.
NOTE:
•
HP recommends not editing any of the pre-supplied files since they are overwritten during
an upgrade.
•
Refer to the STK documentation for details about the file contents.
3. In the task editor, in the file box, specify the new filename.
4. Update the HP ProLiant Hardware Configuration package to the appropriate distribution
points.
Post-OS configuration tasks
The Copy HP ProLiant Post-OS Configuration Support task is tied to the HP ProLiant Post-OS
Configuration package. When executed it copies the contents of the package to c:\$oem$. This
is necessary to get the files onto the local server before the operating system is installed in case
there is no network connectivity after the operating system is installed.
The Perform HP ProLiant Post-OS Configuration task executes c:\$oem$\configure.cmd. The
script performs the following tasks:
•
Installs various drivers such as networking and iLO.
•
Installs the SNMP feature.
•
Installs the HP System Management Homepage, HP Insight Management Agents, HP Insight
Management WBEM Providers, and on ProLiant Gen8 servers the HP ProLiant Agentless
Management Service.
To customize the Perform HP ProLiant Post-OS Configuration task:
1.
Browse to .\OSD\Lib\Packages\HP\ProLiant\PostOSConfig.
2. Edit configure.cmd as needed.
NOTE: HP recommends not removing commands already present, and to keep a backup
copy of any customizations as this file is overwritten during an upgrade.
3. If necessary, copy any additional files referenced in configure.cmd to this folder.
4. Update the HP ProLiant Post-OS Configuration package to appropriate distribution points.
NOTE: To change which agents are installed by default, edit install.cmd in the agent's
subfolder. However, disabling agent installation may result in a loss of functionality.
Post-OS configuration tasks 15