HP OneView for Microsoft System Center User Manual
Page 14
Table 1 Hardware configuration tasks
Underlying STK utility
Description
Task
setbootorder.exe
Sets the system boot order. Setting PXE first in the boot order is
required.
Boot Order
conrep.exe
or
hprcu.exe
Sets the system BIOS configuration.
BIOS
hpacuscripting.exe
Sets the Smart Array RAID configuration.
Smart Array
hponcfg.exe
Sets the iLO 2 or later configuration.
iLO
•
The tasks are designed to set/write a configuration, not get/read/capture a configuration.
•
The Smart Array configuration task is designed to configure only internal controllers and disks,
not network-based storage.
NOTE:
The Set BIOS Configuration task supports all ProLiant generations. If you use a custom
conrep
or hprcu input file, the task sequence will become ProLiant generation specific. For
example, if you specify a custom conrep input file, the task sequence will fail on ProLiant Gen8 or
later target servers.
There is a custom task editor for each task. For example:
The file / parameters combo box allows selecting one of the provided filenames/parameters or
typing in a custom filename/parameters. The pre-supplied files are located in .\OSD\Lib\
Packages\HP\ProLiant\HWConfig
. The files provided are listed in
Table 2 Pre-supplied files
Description
File
Does not set anything
conrep-d.xml
Does not set anything
hprcu-d.xml
Creates a default configuration
acu-rd.ini
Creates one array with RAID 0
acu-r0.ini
Creates one array with RAID 1 (requires two drives)
acu-r1.ini
Creates one array with RAID 5 (requires three or more drives)
acu-r5.ini
Does not set anything
hponcfg-d.xml
14
Reference