HP StoreEver Rack-mount Kits - Manual (Page 8)

2 Drive Installation
Tools Required
A 3/16” (5mm) flat-blade screwdriver or T-15 Torx driver may be required to install a drive in the
1U rack-mount enclosure.
Drive Blank Removal and Installation
CAUTION: To avoid damaging the equipment due to electrostatic discharge, be sure to review
and practice the procedures in Electrostatic discharge before handling the drives.
To install a tape or disk drive:
1.
Remove the top access panel as shown.
Figure 7 Removing the access panel
2. Remove the drive blank:
a.
Pull the spring-loaded button on the right mounting rail up.
b. Slide the assembly forward and then lift up.
Figure 8 Removing the drive blank
3. Remove the mounting brackets from the drive blank.
8 Drive Installation