ADT Security Services PremisePro none - Manual (Page 6)

2
➊
Displays
Fixed Message Display (LCD5501Z Keypad)
Shows the status of your security system using an LCD
showing fixed words/icons and numbers. The display
is described below.
Liquid Crystal Display (LCD5500Z Keypad)
The LCD shows prompts and system information on
two 16-character lines.
Press the keys on the number pad as
prompted by the LCD to view alarms or troubles, to
arm and disarm the system and to bypass zones.
➋
Status Lights
Ready Light
If the Ready light is ON, the system is ready for arm-
ing. The system cannot be armed unless the Ready
light is ON (see “Getting Ready to Arm Your System”
on page 6).
Armed Light
If the Armed light is ON, the system has been armed
successfully.
Trouble Light
A flashing Trouble Light indicates AC Trouble
. If the
Trouble light is ON, see “Identifying Trouble Condi-
tions” on page 15.
➌
Number Pad
To select a function press . To exit a function and
return to the Ready state, press .
➍
Function Buttons
If your installer has enabled them, you can use the
function buttons to access the Stay arm, Away arm,
Zone Bypass, Door Chime and Sensor Reset features
by pressing and holding a button for two seconds.
Refer to the manual for more information on these
features.
➎
Arrow Keys (LCD5500Z Keypad Only)
If “< >” appears, more information can be accessed
by using the
keys. Press to see the pre-
vious function or item of information. Press to
advance the display to the next function or item of
information.
➏
Emergency Keys
Press both * keys for two seconds to send a Fire
message. Press both * Keys for two seconds to
send an Auxiliary message. Press both * Keys for
two seconds to send a Panic message.
IMPORTANT: *(All Keypads) The Fire, Auxiliary
and Panic keys will NOT function unless pro-
grammed by the installer. If these keys are in ser-
vice and the installer has enabled audible
feedback, holding down the key for two seconds
will cause the keypad sounder to beep indicating
that the input has been accepted and sent.
➐
Function Indicators (LCD5501Z
keypad only)
Memory
Upon disarming, if an alarm has occurred while the
system was armed, the Memory indicator will turn on
(See “Viewing Alarms in Memory” on page 11).
Bypass
If the Bypass indicator is ON, one or more zones are
bypassed (See “Bypassing Zones” on page 13).
Fire
If the Fire indicator is on, a fire alarm has occurred (if
the Fire emergency key has been enabled).
Program
The Program indicator will flash when you are pro-
gramming access codes, or performing other pro-
gramming functions. If someone is programming at
another keypad, the Program indicator will turn ON to
indicate that the system is busy.
IMPORTANT: Test system weekly and have any
system trouble conditions corrected by your
alarm installer.