ADT Security Services PremisePro none - Manual (Page 20)

16
Testing Your
System Testing Your Keypad Sounder and Siren
The System Test provides several system tests, and a two-second check of the keypad
sounder and bell or siren.
1. Press [Master Code] .
2. The following will occur:
- The system activates all keypad sounders and bells or sirens for two seconds -- All key-
pad lights turn ON.
- LCD5500Z keypads will light all pixels
- The Ready, Armed, and Trouble LED’s will flash for the duration of the test
3. To exit the function menu, press .
Testing Your Entire System
It is the user’s responsibility to test the system weekly. Ensure you follow all the steps in the
‘Testing Your System’ section above.
NOTE: Should the system fail to function properly, call the service number located
on your keypad(s) immediately.
1. Prior to testing, ensure that the system is disarmed and the Ready light is on.
2. Press and close all zones to return the system to the Ready state.
3. Perform a System Test by following the steps in the previous section.
4. To test the zones, activate each detector in turn (e.g., open each door/window or walk
in motion detector areas).
LCD5500Z keypads will display the following message when each zone (detector) is
activated: “Secure System Before Arming < >”, or “Secure System or Enter Code”. Use
the
keys to view which zones are open. The message will disappear when the
zones are closed.
On an LCD5501Z keypad, the display says “Open” when any zone (detector) is acti-
vated. To see which zones are open, press
. The keypad will scroll the numbers of all
open zones.
NOTE: Some features described above will not be functional unless enabled by
your installer. Ask your installer which features are functional on your system.
Allowing
Computer
Access to Your
System From time to time, your installer may need to send information to or retrieve information
from your security system. Your installer will do this by having a computer call your system
over the telephone line. You may need to prepare your system to receive this ‘downloading’
call. To do this:
1. Press [Master code] at any keypad. This allows downloading for a limited
period of time. During this time, the system will answer incoming downloading calls.
For more information on this feature, please ask your installer.
Turning the
Door Chime
On or Off If your installer has enabled the door chime feature, your system keypads will sound a tone,
or beeps, whenever designated doors or windows are opened or closed. Your installer has
programmed which doors and windows will activate the door chime.
1. Press to turn the door chime feature ON
The keypad will beep 3 times.
2. Press again to turn the door chime feature OFF
The keypad will sound one long beep.
NOTE: This can also be accomplished by pressing and holding for 2 seconds. Chime