ADT Security Services PremisePro none - Manual (Page 22)

18
Setting the
Time and Date You should make sure that your system has the correct time and date. This is important for
the auto-arm feature to function correctly, and for accurate reporting of events.
1. Press [Master Code] .
2. The keypad will now accept 10 consecutive digits:
• Enter the time in hours and minutes using the 24-hour format (00:00 to 23:59).
• Enter the date in months, days and years (MM DD YY).
4. To exit programming, press .
NOTE: If you have an LCD keypad, your installer may have programmed your sys-
tem to display the time and date while the keypad is idle. If this is the case, you can
press the
key to clear the date and time display.
Changing
LCD5500Z
Display
Brightness/
Contrast You can change the brightness and contrast of the LCD display on LCD5500Z keypads.
1. Press [Master code].
2. Use the keys to scroll to either Brightness Control or Contrast Control.
3. Press to select the setting you want to adjust.
4. A) ‘Brightness Control’: There are10 different backlighting levels. Use the keys
to scroll to the desired level.
B) ‘Contrast Control’: There are 10 different display contrast levels. Use the
keys to scroll to the desired contrast level.
5. To exit, press .
Changing
Keypad
Sounder
Loudness You can select from 21 different keypad sounder tones for LCD5500Z and LCD5501Z key-
pads
From an LCD5500Z keypad:
1. Press
[Master Code].
2. Use the keys to scroll to the message ‘Select Option <> Buzzer Control’.
3. Press to select.
4. Use the keys to scroll to the desired keypad sound level.
5. To exit, press .
From an LCD5501Z keypad:
Press and hold the
key until the desired keypad sounder level is reached.