ADT Security Services PremisePro none User Manual
Page 13
A r mi n g an d D i s ar m i n g Y o u r S y s t em : “N o E n tr y ” A r m i n g
9
Re-activate bypassed zones
To fully arm the system when it has been armed in Stay mode:
1. Press
OR press and hold
* for 2 seconds, then your [access code] at
any keypad. The interior zones are now armed.
NOTE:
When you have re-activated the interior zones, you will not be able to enter
areas protected by motion detectors, or open doors and windows. To access these
areas, you must enter your [access code] and disarm the system.
“No Entry”
Arming
If you want to arm the system, and no one else will be entering, you can remove the entry
delay from zones that normally have one.
An entry through any zone will then create an instant alarm.
1. Check that your system is ready to be armed (Ready light is ON)
2. Press
, then your [access code].
• The Armed light flashes as a reminder that the system is armed and has no entry
delay.
• The keypad sounds fast beeps.
• LCD5500Z keypads display “Exit Delay in Progress”.
3. The system is now armed in Stay mode.
Away