ADT Security Services PremisePro none User Manual

Page 15

Section 3: Dealing With Alarms and Emergencies

If you return to the premises and the bell or siren is on

DO NOT ENTER. Contact

local authorities from a nearby safe location.

Read this section carefully so that you will know what to do if your system goes into alarm.

Intrusion
(Burglary)
Alarms

A steady bell or siren indicates an intrusion alarm.

To silence the alarm:

1. Enter your [access code].

2. If the alarm was unintentional, call your central station or local authorities immediately

to avoid an unnecessary response.

3. Check the alarm memory display to see which zone caused the alarm.

Once the source of the alarm has been corrected, the system will return to the Ready
state.

NOTE:

Your system may be programmed so that a sensor reset needs to be per-

formed before the system will return to the Ready state. To reset the detectors,
press

. Ask your installer for more information.

NOTE:

Your LCD5500Z keypad has the capability to display “Communications Can-

celled” if you have central station supervision and if the alarm occurred within a set
communication cancel window. For more information about this feature, ask your
installer.

Viewing
Alarms in
Memory

The alarm memory display shows you which zone (detector) caused the alarm. The alarm
memory is cleared each time the system is armed. Any alarms showing on the system have
occurred only during the last armed period.

CAUTION:

If you return and find that an alarm has occurred while you were

away, it is possible that an intruder is still on the premises. Go to a nearby safe
location, and call your central station or the local authorities to investigate.

LCD5500Z Keypads
If an alarm occurred while the system was armed, LCD5500Z keypads will display “View
Memory <> Zone X”.
1. Use the

keys to view which zone(s) caused the alarm.

2. To cancel the alarm memory display, press

LCD5501Z Keypads
If an alarm occurred while the system was armed, the Memory indicator will flash, and the
keypad will scroll through the zones that were in alarm for 30 seconds after the system has
been disarmed.

1. To cancel the alarm memory display, press

during the 30-second display.

2. After the 30-second period is over, the system will return to the Ready state, but the

Memory indicator will be ON. To view alarms in memory, press

. The display will

scroll the numbers of the zone(s) that were in alarm.

NOTE:

Troubles will not display while the system is displaying alarms in memory.

Reset