Solving problems with plug-in modules, Cd-rom / floppy drive problems – HP OmniBook 7100 Notebook PC User Manual
Page 21
Troubleshooting
7SPZMRK 4VSFPIQW [MXL 4PYK-R 1SHYPIW
1-21
Solving Problems with Plug-In Modules
If your OmniBook plug-in module doesn’t seem to work properly, find the symptom
below that matches your situation. Try the suggestions one at a time.
This section separates problems into the following categories:
♦
CD-ROM / floppy drive problems.
♦
LS-120 drive problems.
♦
DVD drive problems.
♦
Battery problems.
CD-ROM / Floppy Drive Problems
If the CD-ROM drive stops responding
•
Remove and reinsert the CD-ROM disk.
•
Reset the OmniBook.
•
Remove and reinsert the CD-ROM / floppy drive module.
If you cannot boot from a CD in the CD-ROM drive
•
Check that the CD is bootable.
•
Reset the OmniBook.
•
Remove and reinsert the CD-ROM / floppy drive module.
•
Run the BIOS Setup utility to make sure that the CD-ROM drive is the first boot
device. See the OmniBook Reference Guide for instructions on running the BIOS
Setup utility.
If the floppy drive doesn’t work
•
Remove and reinsert the floppy disk.
•
Remove and reinsert the CD-ROM / floppy drive module.