HP ENVY 100 e-All-in-One Printer - D410b - Manual (Page 33)

7 Connectivity
• Add the HP ENVY to a network
• Tips for setting up and using a networked printer
Add the HP ENVY to a network
• WiFi Protected Setup (WPS)
• Wireless with a router (infrastructure network)
• Wireless without a router (ad hoc connection)
• Install the software for a network connection
WiFi Protected Setup (WPS)
To connect the HP ENVY to a wireless network using WiFi Protected Setup (WPS), you
will need the following:
❑ A wireless 802.11 network that includes a WPS-enabled wireless router or access
point.
❑ A desktop computer or laptop with either wireless networking support, or a network
interface card (NIC). The computer must be connected to the wireless network that
you intend to install the HP ENVY on.
To connect the HP ENVY using WiFi Protected Setup (WPS)
▲ Do one of the following:
Use Push Button (PBC) method
a. Select setup method.
❑ Touch Setup.
❑ Touch Network.
❑ Touch WiFi Protected Setup.
❑ Touch Push Button.
b. Set up wireless connection.
❑ Touch Start.
❑ Press and hold the button on WPS-enabled router or other networking device
to activate WPS.
NOTE: The product begins a timer for approximately two minutes in
which the corresponding button on the networking device needs to be
pressed.
❑ Touch OK.
c. Install software.
Connectivity 31