HP Integrity NonStop H-Series - Manual (Page 30)

HP NonStop
RPM User’s Guide Page 30 of 52
SET SORT BYNODE ! sort across all cpus in each node
SET CRIT 50 ! set Critical alert busy threshold 50%
SET WARN 10 ! set Warning alert busy threshold 10%
SET INFO 1 ! set Info alert busy threshold 1%
SET RATE 10 ! set refresh rate in seconds
PB \* ! show Process Busy every 10 sec
Note that the last command in the RPM65CNF file is a display command, so whenever
you enter RPM65, it will automatically pickup all the SET options in the CNF file, and then
will go into display mode displaying PB \* output.
4.3 Starting RPM in VT100 mode
To run RPM in ANSI or VT100 mode enter RPMVT from a TACL prompt.
TACL 1 > RPMVT
Realtime Process Monitor(RPM) - T0877V01.00 - (15APR08)
OBEY $SYSTEM.SYSTEM.RPMVTCNF
!======================================================
!== RPM Configuration settings - 08/04/15 10:00:00
!======================================================
ADD \CHICAGO ! add \chicago to list of nodes
ADD \NEWYORK ! add \newyork to list of nodes
ADD \SANFRAN ! add \sanfran to list of nodes
SET TERM VT100 ! define default term type, VT100, T6530, TTY
SET ENTRIES 10 ! show top 10 busy processes on each cpu/node
SET SORT BYNODE ! sort across all cpus in each node
SET CRIT 50 ! set Critical alert busy threshold 50%
SET WARN 10 ! set Warning alert busy threshold 10%
SET INFO 1 ! set Info alert busy threshold 1%
SET RATE 10 ! set refresh rate in seconds
ZOOM \* ! show both Cpus and Processes every 10 sec
Note that the last command in the RPMVTCNF file is a display command, so whenever
you enter RPMVT, it will automatically pickup all the SET options in the CNF file, and then
will go into display mode displaying ZOOM \* output.