HP Workstation x1100 - Manual (Page 39)

Troubleshooting 36
T
ROUBLESHOOTING
Your board is a complex electronic device and can only be repaired by
authorized technical personnel with special equipment. Do not attempt
to change or repair any parts of this product. Doing so will render your
warranty invalid.
C
OMMON
P
ROBLEMS AND
S
OLUTIONS
If you experience a problem using the Fire GL2, check the following
sections for advice on how to solve your problem.
FAQs
Frequently Asked Questions and their answers may be found at the
Web sites of ATI Inc. Go to www.ati.com and select Support.
No image appears on monitor when computer system is
turned on
♦
Make sure that the Fire GL2 is firmly seated and lined up properly
in its AGP slot, and that the monitor cable is firmly and correctly
connected to the card. For more information, please refer to
Installing the Hardware .
♦
Make sure that your computer and monitor are plugged into
electrical outlets and receiving power.
♦
Is the monitor turned on and receiving power?