HP Workstation x1100 - Manual (Page 21)

Installing the Fire GL2 18
I
NSTALLING THE
S
OFTWARE
♦
Before you Start: Information, Tips and Hints
♦
Software Installation for Windows NT 4.0
♦
Software Installation for Windows 2000
You will need to install the Fire GL2 drivers and software in the
following cases:
♦
After you have installed the card to your system.
♦
After you have re-installed or upgraded your operating system.
Note: To install or remove the Fire GL2 drivers, you need administrator
rights or you must be logged on as a user with administrator rights
under Windows NT and Windows 2000.
Information for Windows NT 4.0 — You must have the Microsoft
Windows NT Service Pack (Service Pack 6 or higher) installed prior to
installing the Fire GL2 drivers. The Service Pack is available from
Microsoft's web page, www.microsoft.com. For most languages you can
also perform the Service Pack 6 update from the Fire GL CD when you
run the Quick Start utility.