Asante Technologies 3524 Series - Manual (Page 74)

74
Appendix A. Troubleshooting
In the unlikely event your switch does not operate properly, follow the troubleshooting tips below. If you still
need help, contact Asanté’s technical support.
Problem Possible Solutions
Power LED is not lit. LED will turn off during system initialization. Check
your power connection. Plug the power cord into
another known working AC outlet.
The 10/100 port Link LEDs are not lit. Check your cable connections. Make sure the
connectors are seated correctly in each port, and that
the correct type of cable is used in each port. See
Chapter 2.5 Connecting to the Network for more
information.
The GBIC Link LED is not lit. Check your GBIC connector. Make sure the cables
are inserted correctly, with the Transmit (Tx)
connector on one side of the link connected to the
Receive (Rx) connector on the other side of the link.
Cannot establish communication to another
device (switch, router, workstation, etc.). •
Make sure the Link LED for the port in use is
on. Make sure you are using the correct
cable type. See Chapter 2.5 Connecting to
the Network for more information on cabling
procedures
•
Make sure the IP address, subnet mask,
and VLAN membership of the switch is
correct
•
Make sure the switch port and the device
both are in the same VLAN
•
Try to connect to a different port
Cannot auto-negotiate the port speed. Make sure that auto-negotiation is supported and
enabled on both sides of the link (in both
devices).
Cannot successfully form a stack •
Check that all the units have the stacking
feature enabled.
•
Check that the hardware modules are
inserted correctly. They should be flush
against the unit.
•
Check the Link LEDs on the units. Check
your cables to ensure they are working.