Asante Technologies 3524 Series - Manual (Page 19)

19
Chapter 3. Configuration
This chapter describes the log in procedure and configuration of the switch via the console or telnet
interfaces. For information on configuring the switch via your web browser, see Chapter 5. Web-Based
Management.
Note: The screens shown are for firmware version 1.1. Earlier versions may have slightly different screens,
but will not effect the basic configuration instructions.
Logging In
When you connect to the Local Management Interface, the “Enter Password” prompt appears. Enter your
password, and then press Enter. The Main Menu appears.
Important! The default password is Asante. The password is case-sensitive; enter it exactly as shown.
After logging in, the Main Menu appears, as shown below.
==============================================================
IntraCore 3524 Remote Management System Version 1.10
Compiled Date: Dec 05 2001 13:53:58
Asante Technologies, Inc.
Copyright (c) 2001 Asante Technologies, Inc.
==============================================================
Main Menu
g General Information
c Configuration
s Statistics
q Close Connection
Command>
From the Main Menu, you can access three submenus:
•
General Information
•
Configuration
•
Statistics
If you are using Telnet, a fourth option for closing the connection is available as well.
Accessing a Submenu
To access a submenu, type the command letter that corresponds with the option you need to use. For
example, type g for General Information.
Note: When configuring certain options on multiple units (stacked switches), the System Unit Map screen
may appear, like the one below. Type the number of the unit to be configured and press Enter.