Installing a dimm – HP ProLiant DL320e Gen8 Server User Manual
Page 46

Hardware options installation 46
o
Memory channel 1 consists of the two DIMMs that are closest to the processor.
o
Memory channel 2 consists of the two DIMMs that are located farthest from the processor.
•
White DIMM slot indicate the first slot of a channel (3-A, 1-B).
•
Memory speed support depends on the type of processor installed. See the technical specification of the
installed processor for more information.
•
The server supports up to 1600 MT/s ECC UDIMMs.
•
The server supports up to 32 GB (4x8 GB) UDIMMs.
•
The server does not support:
o
RDIMMs
o
Non-ECC UDIMMs
o
Elpida DIMMs
•
When installing DIMMs:
o
Populate the DIMM slots in this sequence: 3-A, 1-B, 4-C, 2-D.
o
Use HP-qualified UDIMMs.
For detailed memory configuration rules and guidelines, use the Online DDR3 Memory Configuration Tool
on the HP website
Installing a DIMM
1.
Power down the server (on page
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Do one of the following:
o
Extend the server from the rack (on page
o
Remove the server from the rack (on page
4.
Remove the access panel (on page
5.
Remove the air baffle.
6.
Open the DIMM slot latches.