HP NC532m Dual Port 10GbE Multifunction BL-c Adapter - Manual (Page 11)

Installation and configuration 11
Red Hat
Installing the license key
To install the license key on Red Hat Enterprise Linux systems,
1. Navigate to the \linux\hp-pel\hp-pel-.rhel5.linux.rpm file.
2. Use the following command to install the HP ProLiant Licensing RPM:
rpm -Uvh hp-pel-.rhel5.linux.rpm
3. Add the license key using the following command:
/opt/hp/hp-pel/nalicense -a license_string
If you have an old license and want to add a new license, just add the new license. You cannot
delete the old license.
4. Check the status of all currently installed licenses on the system using the following command:
/opt/hp/hp-pel/nalicense -d [-l ]
Include the -l parameter if you want all the information that normally prints to stdout to be redirected
to the file specified with .
Installing the port-based license utility
To install the port-based Linux iSCSI Offload Utility on Red Hat Enterprise Linux systems,
1. Navigate to the \linux\hp-pbl\hp-pbl-.rhel5.linux.rpm file.
2. Use the following command to install the utility:
rpm -Uvh hp-pbl-.rhel5.linux.rpm
3. The hp-pbl utility is configured to start on system boot-up; however, you can start it immediately after
installation without rebooting using the following command:
/etc/init.d/hp-pbl start
4. The hp-pbl configuration file is a text file located at etc/opt/hp/hp-pbl/hp-pbl.conf. The format of
the configurable MAC parameter is documented in the hp-pbl.conf file. If changes are made to the
hp-pbl.conf configuration file, you must restart hp-pbl using the following command:
/etc/init.d/hp-pbl restart
5. To manually stop the hp-pbl daemon, use the following command:
/etc/init.d/hp-pbl stop
SLES
Installing the license key
To install the license key on SUSE Linux Enterprise Server systems,
1. Navigate to the \linux\hp-pel\hp-pel-.sles10.linux.rpm file.
2. Use the following command to install the HP ProLiant Licensing RPM:
rpm -Uvh hp-pel-.sles10.linux.rpm
3. Add the license key using the following command:
/opt/hp/hp-pel/nalicense -a license_string
If you have an old license and want to add a new license, just add the new license. You cannot
delete the old license.
4. Check the status of all currently installed licenses on the system using the following command: