HP ProLiant DL380 Server - Manual (Page 39)

Control category
The Control category has the following options:
•
“Action mode” (page 39)
•
“Method mode” (page 39)
Action mode
You must specify an Action mode:
•
In Configure mode, you can create new arrays, but you cannot modify existing arrays. The
controller must be connected to unassigned physical drives for this mode to be available.
•
In Reconfigure mode, you can modify existing arrays. For example, you can set up an array
expansion, a logical drive extension, or a migration. These procedures do not destroy data,
unless you specifically want the data to be deleted. In this mode, ACU does not change an
existing option setting unless you specifically script a different value for that option.
Method mode
The default value for this option is Auto. If you want to use Custom mode, you must specify it.
In Auto mode, ACU can perform an expansion, extension, or migration without user intervention
if the values that you set for other options imply that such an operation is necessary.
Controller category
The Controller category has the following options:
•
Controller (page 39)
•
ChassisName (page 40)
•
ClearConfigurationWithDataLoss (page 40)
•
DeleteLicenseKey (page 40)
•
DPOEnable (page 41)
•
ElevatorSortEnable (page 41)
•
ExpandPriority (page 41)
•
IRPEnable (page 41)
•
LicenseKey (page 40)
•
MNPDelay (page 41)
•
PreferredPathMode (page 40)
•
QueueDepth (page 41)
•
ReadCache (page 40)
•
RebuildPriority (page 41)
•
SSPState (page 41)
•
SurfaceScanDelay (page 41)
•
WriteCache (page 40)
Controller
You must enter a value for this option because it identifies the controller that you want to configure:
•
All —Configure all detected controllers in the system.
•
Slot [N][:M] —Configure the internal controller in slot number N, or the external controller
at port M in slot N.
Using HPACUSCRIPTING 39