Aiwa XR-H33MD - Manual (Page 48)

2 Press the DOWN or UP button to designate the hour, and press the SET button.
The hour stops flashing and the minute starts flashing.
3 Press the DOWN or UP button to designate the minute, and press the SET button.
The minute stops flashing on the display and the clock starts from 00 seconds.
To display the current time
Press CLOCK on the remote control while pressing SHIFT. The time is displayed for 4 seconds.
However, the time cannot be displayed during recording.
To switch to the 24-hour standard
Press the CLOCK button on the remote control and then press the
„ button within 4 seconds.
Repeat the same procedure to restore the 12-hour standard.
If the clock display flashes
This is caused by a power interruption. The current time needs to be reset.
If power is interrupted for more than approximately 24 hours, all settings stored in memory after purchase need to be
reset.
SETTING THE TIMER
The unit can be turned on at a specified time every day with the built-in timer.
Preparation
Make sure the clock is set correctly.
Use the remote control.
1 Press the TIMER button repeatedly while pressing SHIFT until
¥ appears on the display, and press
SET within 6 seconds.
¥ is displayed and the hour flashes.
NOTE
If you press SET after 6 seconds, another operation may start.
2 Designate the hour of the timer-on time by pressing the DOWN or UP button, and press