ADC EDU-409 - Manual (Page 13)

150-409-115-05, Issue 5 Installation
EDU-409 List 1 January 26, 2000 7
I
NSTALLATION
This section describes the compatibility and installation for the EDU-409
List 1.
C
OMPATIBILITY
The EDU-409 List 1 is compatible with the following ADC outdoor
enclosures:
• HRE-500, single-slot unit
• HRE-458, 10-slot unit
• HRE-819, 12-slot unit
I
NSTALLING THE
EDU-409 L
IST
1
To install the EDU-409 List 1 in an enclosure, perform the following steps
and refer to the enclosure installation manual for information about cabling,
proper connections, grounding, and line and local power.
To install the doubler unit, slide the doubler unit into the card guides for the
desired slot (see
Figure 2 on page 8 ). Then push the unit into the enclosure
until it is seated in the card-edge connector. The unit should snap into place,
indicating that it is properly seated.
This product incorporates static sensitive components.
Proper electrostatic discharge procedures must be followed.