American Dryer Corp. ADG-464 - Manual (Page 15)

11
B. LOCATION REQUIREMENTS
The model ADG-464 dryer requires 36-inches (91.44 cm) of space on each side of the dryer and 36-inches
(91.44 cm) of space behind the unit for ease of maintenance and tilting. The dryer must be leveled for proper
operation. If shimming is required, put (24.13 cm) 9-1/2” x 9-1/2” (24.13 cm) metal shims under the base feet.
The dryer must be lagged to the floor.
IMPORTANT: Dryer should be located where a minimum amount of exhaust duct will be necessary.
1. The dryer must be installed with a proper exhaust duct connecton to the outside.
2. The dryer must be installed with provisions for adequate combustion and make-up air supply.
CAUTION: This dryer produces combustible lint and must be exhausted to the outdoors. Every 6
months, inspect the exhaust ducting and remove any lint build up.