BendixKing KLN 90B - Manual (Page 172)

6-24
3. Use the left inner and outer knobs in the normal
manner to define the desired waypoint.
4. Press E to display the waypoint page for this
identifier. If the waypoint is correct, then press E a sec-
ond time to confirm the waypoint page. The new waypoint
is added to the waypoints that make up the SID or STAR
procedure.
To delete an individual waypoint in a SID or STAR
procedure use the following steps:
1. Use the left knobs to select the FPL 0 page on the left
side of the screen.
2. Rotate the left outer knob to place the cursor over the
waypoint to be deleted.
3. Press @ . The letters DEL (delete) will appear to
the left of the identifier and a question mark will appear to
the right of the identifier.
4. If this is the desired waypoint to delete, then press
E . If it is not the desired waypoint, press @ .
NOTE: Adding waypoints to or deleting waypoints from
SID or STAR procedures does not change the way that
they are stored in the published database.
To change or delete an entire SID or STAR procedure
from the active flight plan use the following steps:
1. Use the left knobs to select the FPL 0 page on the left
side of the screen.
2. Turn the left cursor on by pressing the left C . Move
the cursor over the SID or STAR procedure header by
using the left outer knob.
3. With the cursor over the procedure header, press E
to change the SID or STAR or press @ and then E to
delete the entire procedure.
NOTE: Any waypoints manually added to a SID or STAR
will be deleted if the SID or STAR is changed or deleted
using the above procedure.
Rev 1