Airlink RJ-11 - Manual (Page 45)

Host RJ-11 IP Gateway User Guide, version 44
AT Commands
• If no phone number (IP address) is specified, the Destination IP Address configured for the port
is used.
• If no port number is specified, the Destination TCP Port configured for the port is used.
• The source port for the TCP connection follows the Source TCP Port configured for the port.
Port Settings
Most of the serial port settings (like baud rate) are controlled by the configured port settings on the
device server. Modem emulation does not support changing these from AT commands.
Fixed format aaabbbcccddd or
192168001001
12 digit IP address, each number is three decimal
digits with leading zeroes
Optional port
number :xxxxx Decimal TCP port number from 0..65535
Format Example Notes