Bosch HDI7052U - Manual (Page 6)

6
Parts provided:
• Anti-Tip Bracket
• 2 wood screws
• 2 anchorless concrete screws
• Foam Tape
• Terminal Lugs (For Use With Hard Wire
Installations)
Note: not necessary for Canadian installations
Tools and parts needed:
• Range Power Supply Cord Kit (240V -30 Amp)*
• Measuring Tape
• Phillips Head Screwdriver
• 1-4" Wrench
• Pencil
• T-20 Torx Screwdriver
• Level
• Drill and Drill Bit (3/16“ masonry bit for
concrete screws)
• Soapy Water
• Pipe Wrench
• Telon® Tape**
• Channel Lock Pliers
• Gas Leak Test Solution
• Gas Supply Line
• Gas Shut Off Valve
• Safety Gloves and Goggles
• Tape (Optional)
• Cloth or Cardboard (Optional – to Protect Floor)
* Not needed for Canadian installations Canadian
units are shipped with the power cord already
installed.
** Telon is a registered trademark of DuPont
Additional Parts Needed For
Hard Wire Installations
• Flexible Conduit (For Hard Wire Installation Only)
• Torque Wrench (For Hard Wire Installation Only)
Note: Power Supply Cord Kit Not Necessary For Hard
Wire Installations
General Information
Overall Dimensions
Dimension Inches Centimeters
Height 36" 91.44 cm
Width 31" 78.74 cm
Depth 25 ⅝" 65.09 cm
Level
For best results, cabinets, countertops walls and
floors in the installation location should be as level
and plumb as possible. Variance may cause damage
to countertops and floors during installation, could
jeopardize the seal around the cooktop and may
adversely affect cooking and baking performance.
Prepare Unit
Remove all packaging material and discard
, WARNING
Remove all tape and packaging before using the ap-
pliance. Destroy the packaging after unpacking the
appliance. Never allow children to play with packag-
ing material.
Tips:
Place the range on a piece of the cardboard to
protect floors.
Remove drawer and set aside
1. Pull drawer all the way out.
2. Locate locking clips on the rails, one on each side.
3. Push up on the clip on the left rail. Pull the drawer
out until clip locks into place.
4. Push down on the clip on the right rail. Pull the
drawer out until clip locks into place.
5. Pull the drawer straight out and set aside.
6. Push rails into range.
Remove oven door and set aside
, WARNING
When removing the door:
• Make sure oven is cool and power to the oven has
been turned off before removing the door. Failure
to do so could result in electrical shock or burns.
• The oven door is heavy and fragile. Use both hands
to remove the oven door. The door front is glass.
Handle carefully to avoid breaking.
• Grasp only the sides of the oven door. Do not grasp
the handle as it may swing in your hand and cause
damage or injury.
• Failure to grasp the oven door irmly and properly
could result in personal injury or product damage.
• To avoid injury from hinge bracket snapping closed,
be sure that both levers are securely in place be-
fore removing door. Also, do not force door open
or closed - the hinge could be damaged and injury
could result.
Preparation