Bosch HDI7052U - Manual (Page 10)

10
Install Strain Relief
Place strain relief in knockout below terminal block.
, WARNING
The strain relief provided with your range cord must
be properly installed.
Strain reliefs vary. Carefully read and follow the in-
structions included with your strain relief.
1. In the knockout panel below the terminal block,
remove the knockout that fits your strain relief.
2. Feed range cord through hole and strain relief up
to terminal block. Allow for slack in the cord be-
tween the strain relief and terminal block.
3. Once cord length/slack has been adjusted, attach
strain relief per instructions included with strain
relief.
Feed range cord through strain
relief in knockout panel here.
Electrical connection
(found behind terminal block cover)
Tip: The knockout panel (below the terminal block)
can be removed from the range to install the strain
relief: Remove panel from range, install strain relief
in panel and reattach. DO NOT remove entire range
back panel.
, WARNING
Risk of Electric Shock or Fire. Frame grounded to
neutral through a ground strap. Grounding through
the neutral conductor is prohibited for new branch-
circuit installations (1996 NEC), mobile homes, and
recreational vehicles, or in an area where local codes
prohibit grounding through the neutral conductor.
For installations where grounding through the neu-
tral conductor is prohibited, (a) disconnect the link
from the neutral, (b) use grounding terminal or lead
to ground unit, (c) connect neutral terminal to lead
branch circuit neutral in usual manner (when the
appliance is to be connected by means of a cord kit,
use 4-conductor cord for this purpose).
Use only cord kits rated 125/250 volts (minimum),
30 amperes and labeled “For Use with Ranges”.
Strain relief provided with cord must be installed per
instructions included with cord.
, WARNING
To prevent electrical shock, the grounding prong on
the range cord should not be cut or removed under
any circumstances. It must be plugged into a match-
ing grounding type receptacle and connected to a
correctly polarized 240- Volt circuit. If there is any
doubt as to whether the wall receptacle is properly
grounded, have it checked by a qualified electrician.
Four Wire Range Cord Connection
(Recommended Method)
1. Disconnect electrical power at breaker box.
Remove the terminal block cover to expose the
terminal block.
2. Remove top nut, star washer, and round washer
from each post.
Note: DO NOT remove last round washer, last nut or
internal wiring leads.
3. Remove screw from bottom end of ground strap.