Canon imagePROGRAF iPF655 - Manual (Page 899)

Insufficient paper for job
Cause Corrective Action
The printer has received a print job longer than the amount of
roll paper left when ManageRemainRoll in the Control Panel
menu is On. Press ▲ or ▼ to select Print, and then press the
OK button to resume printing.
However, the roll paper may run out during the
print job and you may not be able to print all of the
document.
Press ▲ or ▼ to select Change Paper, and then
press the OK button to stop printing.
Either change the printer driver Paper Source set-
ting or the GL2 Settings > Paper Source setting
in the printer menu or replace the roll with a roll
that has enough paper for the print job, and then try
printing again.
(See "Removing the Roll from the Printer.")
→P.643
(See "Loading Rolls in the Printer.") →P.637
This paper cannot be used.
Cause Corrective Action
Paper smaller than the printer's minimum suppor-
ted size has been loaded. Push the Release Lever back and load paper of the correct size.
(See "Paper Sizes.")
→P.627
Paper has been loaded that is too small to print the
test pattern for printhead adjustment or nozzle
checking. Push the Release Lever back and load unused paper of A4 size or
larger. More than one sheet may be required depending on the ad-
justment.
Roll printing is selected.
Cause Corrective Action
You have attempted to print a test print sheet
or other printer status information on a roll,
but no roll is loaded. Press ▲ or ▼ to select Load Roll Paper, and then press the OK but-
ton. Load the roll, and then print.
(See "Attaching the Roll Holder to Rolls.")
→P.633
(See "Loading Rolls in the Printer.") →P.637
To print on sheets, follow these steps.
1. Press ▲ or ▼ to select Stop Printing, and then press the OK but-
ton to stop printing.
2. Load a sheet and try printing again.
(See "Loading and Printing on Sheets.") →P.9
Error Message > Messages regarding paper >
iPF655 Insufficient paper for job
13
883