Alpine iDA-X001 - Manual (Page 12)

10
-EN
Setting PTY31 (Emergency Broadcast)
reception
Turn PTY31 (Emergency Broadcast) reception ON/OFF.
1
Press and hold FUNC./SETUP for at least 2
seconds to activate the SETUP selection mode.
2
Turn the Center Jog Dial to select the Tuner mode,
and then press ENT.
Bluetooth General Display iPod Tuner
3
Turn the Center Jog Dial to select PTY31 and then
press ENT.
4
Turn the Center Jog Dial to select On or Off, and
then press ENT.
If you set to On, emergency broadcasts are received
regardless of source. “ALARM” is displayed during
reception.
5
Press and hold BACK for at least 2 seconds to
return to normal mode.
When an emergency broadcast is received, the volume
level will be automatically changed to the memorized level
in the traffic information mode. For details, refer to
“Receiving Traffic Information” on page 10.
• Pressing BACK during the procedure will return to the previous
mode.
Setting the Time to automatically Adjust
When you set to ON, the time is automatically adjusted by RDS data.
1
Press and hold FUNC./SETUP for at least 2
seconds to activate the SETUP selection mode.
2
Turn the Center Jog Dial to select the Tuner mode,
and then press ENT.
Bluetooth General Display iPod Tuner
3
Turn the Center Jog Dial to select Auto Clock, and
then press ENT.
4
Turn the Center Jog Dial to select On or Off, and
then press ENT.
5
Press and hold BACK for at least 2 seconds to
return to normal mode.
• Pressing BACK during the procedure will return to the previous
mode.
Receiving Traffic Information
1
Press and hold BAND/TA for at least 2 seconds so
that the “TA” indicator lights up.
When a traffic information station is tuned in, the “TP”
indicator lights up.
Traffic information is heard only when it is being broadcast.
If traffic information is not being broadcast, the unit is set in
the standby mode. When a traffic information broadcast
begins, the unit automatically receives it and the TRF Info
screen is displayed.
When the traffic information broadcast is over, the unit will
automatically set in the standby mode.
• If the traffic information broadcast signal falls below a certain level,
the unit remains in the receiving mode for 1 minute. If the signal
remains below a certain level for over 1 minute, the “TA” indicator
blinks.
• If you do not want to listen to the traffic information being received,
lightly press BAND/TA to skip that traffic information message. The
TA mode will remain in the ON position to receive the next traffic
information message.
• If the volume level is changed while receiving traffic information, the
changed volume level will be memorized. When traffic information is
received next time, the volume level will be automatically adjusted to
the level memorized.
PTY (Programme Type) Tuning
1
Press FUNC./SETUP to activate the Function
mode.
2
Turn the Center Jog Dial to select PTY, and press
ENT, while the unit is in Radio (FM receiving) mode.
The PTY Select screen is displayed.
3
Turn the Center Jog Dial to choose the desired
programme type.
4
Press ENT after selecting the programme type to
start searching for a station in the selected
programme type.
The chosen programme type display blinks during
searching and lights when a station is found.
If no PTY station is found, “No PTY” will be displayed for 10
seconds.