Canon imagePROGRAF iPF9400S - Manual (Page 4)

4
• Remove the tape on the pieces to prevent
slippage by pulling the tape across the
pieces from above when peeling off.
Caution
MEMO
MEMO
6
8 9 10
11
12 13
4
a
5
a
b
a
a
d
b
b
c
e
e
7
14
3
• Do not cut the black belts around the printer
until step 11. When the black belts are cut,
Tipping installation is no longer possible.
Remove the bottom cardboard sheet and
the pallet. Assemble the cardboard stand
holder as shown and put the holder to
the bottom side of the printer. Let the
side with round holes (a) face the printer.
Use scissors to cut openings in the plastic
covering as shown. Pull the covering apart
with both hands to expose the sections of the
printer where the Stand will be attached.
Bend the front flap of the cardboard stand
holder forward as shown. Collapse the
holder and remove the holder from under
the stand.
Place the bottom sheet (a) under the
printer. Have four people hold the printer
and Stand on both ends, two people on
each end. As you support the printer, tip
it forward, pivoting it on the pieces of the
Stand to prevent it from slipping (b).
Remove the black belts (a) from the
printer.
Rest the Stand on its side on the
cardboard stand holder. Adjusting the
positions for attachment to the printer,
use an Allen Wrench to tighten four M4
screws on both sides, attaching the stand
securely to the printer.
Remove the packaging material and the
plastic covering from the other side of the
printer the same way.
• Be careful to prevent the Stand from slipping.
Remove the black belts from around the
printer and remove the top packaging
material.
While two people hold the carrying handles
under the printer on one end and lift the
printer a little, have a third person remove the
packaging material and the plastic covering
from under the printer. After the packaging
material has been removed, lower the printer.
• To avoid scratching the floor, be sure to
place the bottom sheet on the floor.
Remove the packaging material (b), the
box (c) with the Rewind Spool inside, the
plastic covering (d), and the pieces (e)
attached to casters to prevent slippage.
• When cutting the black belts, be careful not
to let the belts fly away from the printer.
Lifting installation: In the case of installation by six people
Remove the packaging material covering
the sections of the printer where the
Stand will be attached.
Remove the Sample Paper. Turn the joints to pull out of the bottom
cardboard sheet on top of the pallet, and
then remove the cardboard stand holder.