Canon REALIS SX80 MARK II - Manual (Page 9)

9
CHAPTER 1 • Introduction
Complete the dialog with necessary information and click the [OK] button.
4
Category Description
IP address Enter an IP address of the projector, in "XXX.XXX.XXX.XXX" form.
Port number Enter a port number to be used, in one-byte numbers. Default
value is set to "7142."
Timeout Enter a number of seconds to time out, from 1 to 9.
Note
An error message will appear and settings will not be registered if a value -
of an entry is invalid or insufficient. Correct it as required.
Entries will be cancelled if [X] (Close) or [Cancel] button is clicked before
-
clicking the [OK] button.
To change an IP address, select an item from the discovery range list and
-
click the [Edit] button to reconfigure the settings.
To delete an unnecessary IP address, select an item from the discovery
-
range list and click [Delete].
Projectors may doubly display when the IP address of a projector is
-
changed. In this case, delete the projector with an old IP address.
COP
Y